LED flash is made from 5 Power LEDs of 50W total power.
These LEDs, thanks to their construction, emit huge luminous flux and effectively dissipate heat from the connector when the device is in use.
The LEDs are covered with resin, which ensures that the construction of the lamp is waterproof and highly resilient to shocks and impacts.
BASIC LED DATA:
- Power: 50 W flash.
- Luminous flux 6000 lumens.
- Color temperature 5500-6000 K.
- Does not interfere with radio waves.
- Integrated temperature sensor.
- Resilient to shocks, impacts, water.
- LED cooperates with the ST-201 controller.
- Small size: Diameter 34 mm.
- LED weight: 70g.
- Range of about 8 km in the dark !!!
BASIC ST-201 CONTROLLER DATA:
- Supply voltage: 10v 30v DC.
- Aluminum housing resilient to shocks, impacts, water.
- Protection: thermal, short-circuit, current, against reverse polarity, against battery damage, against automatic shutdown.
- Option of automatic activation after connecting the power supply (possibility of putting the controller in a hard-to-reach place).
- Possibility of assembling the switch out of the controller (a ST-201 switch extension kit is available).
- lluminated LED button on the switch that signalizes working functions and messages (such as low battery, not connected lamp etc.).
- Possibility of modifying the settings and disabling some working functions by connecting to a computer.
- Measurements: 145mmx25mm (5.70 x 0.98 inch.).
- Weight: 120g.
6 WORKING FUNCTIONS:
- Single flashes with a frequency of 43,50,55 flashes per minute.
- Single flashes with a frequency of 43,50,55 flashes per minute + steady light (position lamp).
- Double flashes with a frequency of 43 cycles per minute.
- Triple flashes with a frequency of 43 cycles per minute.
- 360 degrees flashlight (additional lighting of the start and landing, and assembling or disassembling of the equipment).
- SOS light signal activated by an integrated overload sensor or manually.
THE SET INCLUDES:
1. 50W 6000lm LED lamp with a connector.
2. Assembly set for the LED lamp for a 20 mm pipe.
3. ST-201 controller.
4. Assembly set for the ST-201 controller for a 20-30 mm pipe.
5. ST-201 connecting cable with protection tapes.
6. Power supply cable.
7. USB cable.
8. Cable tie 10 pcs.
9. Operating manual.
THE SET ALSO INCLUDES:1x Li-Ion Power Pack Kit 12.6 Volt
3x LG INR18650 MH1 3.2AH Batteries (This Kit Contains Batteries, The Battery Frame, Outer Case & Charger)
BATTERY PACK BASIC DATA:
- Output voltage: 12.6V.
- Short circuit protection.
- Overload protection.
- Over-discharge protection.
- Current protection.
- Maximum continuous discharge current: 5-8 A.
- Maximum momentary discharge current: 10 A.
- Work temperature: - 40°C ---- + 50°C.
- Weight with storage batteries: 260 g.
- Measurements ( length/width/height ): 11,5cm/8cm/3.5cm.
- Please Note Battery Pack Colour Supplied, May Vary From Black to Brown
ALSO Included:
1. A three-battery protective frame.
2. A case for the protective frame.
3. A Velcro to mount the case.
4. A Li-ion charger 12.6V 1A with a LED. **
5. 3 x LG INR18650 MH1 3,2Ah.
6. Operating manual.
Supported LI-ION 18650 Cells:
SANYO NCR18650GA 3450mAh , LG INR18650 MH1 3200mah ,PANASONIC NCR18650PF 2900mAh, SONY US18650V3 2250mAh , SAMSUNG ICR 18650 22P 2150mah.
** (We request that you to provide information about the plug: EU, US, UK; otherwise we will send it according to the country of order) **